I’m only going to say that this one was really time consuming. I had to remove a bunch of components from both PCBs, mount a few of them on the main board, then cut the main board to make it fit inside the enclosure and keep mounting more components on the back of it. Then drilling the new enclosure and doing the wiring.

Work to the main board done.

Drilled enclosure.

And the wiring done! I had to do a bit of trouble shooting. It turned out I had forgotten to connect the output of the  input buffer to the rest of the circuit so there was no signal going through.

I’m happy how it came out. It doesn’t sound that bad either, really good actually!

Advertisements